Correct disassembly and repair procedures for heat exchanger plates

2017-07-11 View Original

Thread Content

1. First, use a tape measure to determine the distance between the two clamps, and make a note of it for use during installation later； 2. Disassemble each flange and open the drain port to release the remaining water inside ； 3. After the water has been drained, lay the plate heat exchanger flat and loosen the bolts evenly ； 4. Then remove the plates one by one and clean them.

Reply #2 2017-07-11

OP, this is a bit too simple; it would be great if you could explain in detail the background behind doing this. :lol

Reply #3 2017-12-15

It would be fine to collect some pictures and attach them

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.

Correct disassembly and repair procedures for heat exchanger plates

Thread Content

Submit a Project

Disclaimer

Quick Links