Seeking advice on plate heat exchangers
Thread Content
May I ask if the engineering diameters of the interfaces for the two circuits in a plate heat exchanger are the same? Are there any circuits with different inlet and outlet sizes? For example, Circuit 1 has an inlet and outlet of DN100, while Circuit 2 has an inlet and outlet of DN65. Thank you!
It can be increased if it can handle the traffic volume
For the diameter of plate heat exchangers, it is not necessary for them to be identical; under certain conditions, the diameters of the tubes on the same side can also differ, depending on the flow rate during operation.
To meet the traffic requirement, it can only be reduced, not increased
The diameter size is related to the flow rate within the pipe, and it can be adjusted appropriately according to the design requirements.