Heat exchanger design in sw62011
Thread Content
In the heat exchanger design of sw62011, the flange torque coefficient is 0; please check and modify the data for the mating flanges before performing another calculation. This number applies to that type of flange, namely the standard flange NB/T47022
First, enter the flange data and then perform the calculation; the values will be available for the fixed tube sheet side
This is because you calculated the tube sheet without entering the data for the front-end tube box flanges; once the complete flange data is entered, calculating the tube sheet will work fine
Hey, could you send me the download link for SW6-2011?
The flange torque coefficient is 0; please check and modify the data for the mating flanges before recalculating. The actual bolt cross-sectional area is smaller than the required bolt cross-sectional area; the verification fails. These two issues are actually related to the washer material: (
What does that even mean? The calculation of flanges is, after all, a calculation of the system formed by flanges, pipes, gaskets, and bolts. Why do you keep thinking that there’s no connection between them?