Frosting problem in liquid nitrogen vaporizers
Thread Content
Currently, the vaporizers behind the liquid nitrogen and liquid oxygen storage tanks, as well as the pipelines, are constantly frosting over, and manual defrosting is not timely enough. Are there any methods that can be used to prevent frosting during normal equipment operation? A few tips from an expert, thank you.
Especially the pipes connecting to the liquid nitrogen storage tank suffer the most from frosting; the vaporizer itself is fine.
It’s very difficult to prevent frost, unless there is no water vapor in the air or the air is isolated!
First, we need to confirm what kind of device your question is about. Is it that type of low-temperature liquid storage tank? If so, frost forming on the tank indicates a vacuum issue; it is necessary to contact the manufacturer to have the tank subjected to vacuum treatment (evacuation) ； The problem with the carburetor is that it’s a self-pressurizing type; frost formation during use is a normal phenomenon. If the heat exchange area is small while a large amount of vaporization is required, it is recommended that, in the absence of the possibility of replacing the vaporizer, an additional axial flow fan be installed to increase the gas flow for heat exchange – this is the best approach, and it’s worth giving it a try.
It’s normal; on some pipelines carrying cryogenic fluids, there can be several inches of ice buildup.
It’s normal; on some pipelines carrying cryogenic fluids, there can be several inches of ice buildup.
But the frost buildup is thick, especially in the pipes that connect the storage tanks such as liquid nitrogen to the vaporizers
Mainly, the pipeline connecting the liquid nitrogen tank to the vaporizer is the one where frosting is most severe. I’m wondering if there are any good ways to remove this frost? Can insulation sleeves or something similar be used on the pipes to prevent frosting?
If it’s a connecting pipe that needs to be vaporized, then just use it as part of the vaporization process. If you don’t need it to vaporize, insulation is fine.