Seeking advice on lifting 0.6mm stainless steel sheets
Thread Content
When lifting heat exchanger plates in a company, it is important not to damage their surface or edges; the edges of these plates are quite sharp. In the past, plastic straps were used as protective covers, and they proved to be very effective. However, I can’t find the flat strap cover right now. It has great strength, but its length is only one meter, which is not long enough. Where can I buy this type of sleeve that is 3 meters long? Are there any alternative lifting methods? PS: This sleeve is extremely expensive. . .
Consider whether it can be solved with specialized tooling.
The three-meter sheath used before was imported. I’m here for purchasing, not production; I still hope to be able to get something better
Create a sandwich layer and put the thin steel plate inside. . .