【HVAC Version】Daily Question 20180324
Thread Content
This post was last edited by hesonchang214 on 2018-3-27 09:33. In the calculation of the flow rate for the water supply network in indoor dormitories in our country, if the calculated flow rate is less than the rated water supply flow rate of the largest sanitary fixture in that pipe section, which parameters should be used as the design flow rate per second? ( ) (A) The sum of the rated water supply values; (B) The calculated value; (C) The rated flow rate of the largest sanitary fixture; (D) The average value. Answer: C
(C) A maximum rated capacity for sanitary fixtures
(A) Superimposed value of water supply quota
In the calculation of the flow rate for the water supply network in indoor collective dormitories in our country, if the calculated flow rate is less than the rated water supply flow rate of the largest sanitary fixture in that pipe section, which parameters on that pipe section should be used as the design second flow rate (C)? (A) The sum of the rated water supply values; (B) The calculated value; (C) The rated flow rate of the largest sanitary fixture; (D) The average value
(C) A maximum rated capacity for sanitary fixtures