Questions about steam jet pumps
Thread Content
I have questions regarding steam jet pumps; I would appreciate some guidance from experts! ! Thank you so much! 1 What are the differences in suction capacity caused by different positions of the inlet of a steam jet pump? See Figure 2: Which performs better, a conical nozzle or a bell-shaped nozzle? See attached figure
It should be in a better position, right where the flow velocity of the high-pressure medium is highest
Pressure energy is converted into kinetic energy, driving the gas to be ejected into the expanding tube. A low-pressure area is formed. Personally, I think the second type of nozzle is better than the first; the first type is the one I have seen
Pressure energy is converted into kinetic energy, driving the gas to be ejected into the expanding tube. A low-pressure area is formed. Personally, I think the second type of nozzle is better than the first; the first type is the one I have seen
Pressure energy is converted into kinetic energy, driving the gas to be ejected into the expanding tube. A low-pressure area is formed. Personally, I think the second type of nozzle is better than the first; the first type is the one I have seen
Pressure energy is converted into kinetic energy, driving the gas to be ejected into the expanding tube. A low-pressure area is formed. Personally, I think the second type of nozzle is better than the first; the first type is the one I have seen
Pressure energy is converted into kinetic energy, driving the gas to be ejected into the expanding tube. A low-pressure area is formed. Personally, I think the second type of nozzle is better than the first; the first type is the one I have seen
Thank you. Can it be understood that bell-shaped nozzles are better than cone-shaped nozzles?