Help needed
Thread Content
The high flash liquid level is consistently above the specified range, but the low flash liquid level remains relatively stable. Increasing it automatically also results in a normal rise, which indicates that water from the high flash area is entering the low flash area; however, the level still stays above the limit. I need experts to help solve this issue!
There are a few questions that the original poster needs to answer: 1. Besides abnormal liquid level, are there any other issues with high flash? Is the temperature higher than before? Is it overheated or overpressured? 2. Is the amount of water discharged through vaporization greater than before? 3. Is the high-flash level gauge referred to by the poster a remote level gauge or an on-site level gauge? Is the high-flash level gauge double-flanged or single-flanged? Are remote level gauges and local level gauges integrated or measured separately? My intuition tells me that the high-reflectance level gauge in the original poster’s home is likely of the double-flange type; it’s very possible that the pressure tapping pipe on the negative-pressure side of the gauge is blocked, that is, the one located on the side at a lower installation height. It’s also possible that the level gauge float is stuck due to scaling, but more detailed information from the poster is needed in order to make a judgment.
Yes, with the information provided by the original poster, it’s still difficult to determine what’s going on; there isn’t enough useful information
Is the high-flash separation pump also at full scale?