Class 2 Super Klausgaard incinerator, jacket pipes for burning exhaust gases in the thermal power plant boiler
Thread Content
The last edit to this post was made by liaifeng on 2018-9-10 at 20:54. I would like to ask: which company does a good job in manufacturing the jacketed pipes used to convey the exhaust gases from level 2 Super Klaus G combustion furnaces to the boilers in thermal power plants for burning?
Are you planning to add a jacket? Are you worried about pipe blockage? We have pipe corrosion; we plan to replace the pipes with ceramic-lined ones
I would like to ask which manufacturers are good at producing ceramic-lined pipes? Is this ceramic-lined pipe resistant to dilute acid corrosion?
Our logistics department says it’s pretty good; I’m not sure about the manufacturer
Ceramic-lined pipe, with a jacket for heating?
The lining tube is not afraid of corrosion; it’s afraid of clogging!
There is also corrosion and blockages, especially in the area near the boiler. Proper heat tracing can serve as a substitute for a jacket. The jacket is too expensive, and it’s troublesome for maintenance and repairs.
This post was last edited by Meng Tan Jian ④ Rim grass on 2018-9-19 at 16:15. There are many ways to reduce sulfur dioxide levels. Why integrate it with thermoelectric systems? The requirements for thermoelectric systems seem to be higher, around 50. The sulfur dioxide levels resulting from sulfur recovery are relatively low, and the pressure in the exhaust gas furnace is low; if the pipelines are long, it may not be possible to transport the gas there, and fans might be necessary. Pipelines often come with extensive heat tracing as well.