UOP Continuous Reforming Batch Control Mode
Thread Content
How does the batch control mode of UOP continuous reforming operate?
1. It can be manually switched to batch mode. 2. The pressure difference between the secondary gas and the purge section is too high (it is generally set between 15 and 50 kPa, depending on the catalyst circulation rate and the values specified by UOP); after a certain number of cycles, once the pressure difference stabilizes, it can be switched to continuous mode
How to switch to “Manual Mode”? Is batch mode controlled by the CRCS system? Could you provide some information?
Foreigners don’t allow you to change it casually\ud83d\ude01
Manual control can easily lead to unstable differential pressure! It can also cause damage to the catalyst! It can be avoided if you know how to control the logic!