When heating up the catalyst startup reactor, should a gate valve or a globe valve be used for the fuel gas manual valve?
Thread Content
On our end, the furnace is heated using fuel gas, and currently a gate valve is used to control the flow of this gas; I personally think it would be better to use a globe valve for regulation. Also, ask if anyone uses remote control.
What are the reasons you think make globe valves good? What is the basis for that? Remote control for oven heating is now very common; just add a control valve and it’s done!
Aren’t they all double-valve? One gate valve and one globe valve
I heard that globe valves are easier to control in terms of flow rate, and it’s easier to determine the appropriate opening degree when heating up. For example, the increase in amount for each 1/5 turn of the globe valve is always fixed
Is the gate valve fully open, and is the globe valve opened gradually depending on the temperature?