Process of pressurizing the catalytic device
Thread Content
How should the flare at the compressor inlet be adjusted during the turbine acceleration phase, before the rich gas is fed into the absorption and stabilization system? Does the flare volume remain unchanged before the rich gas is combined with the backstream?
A flare is installed at the compressor inlet to control the reaction pressure; counter-rotation is used in conjunction to regulate the amount of gas released, thereby preventing ignition of the flare. It is preferable to recover all the gas using a gas holder, with exceptions in case of abnormal conditions.
Share the specific steps and experiences
In simple terms, before injecting fuel, gas is first introduced, with the compressor running at low speed. At 520 degrees, spray gasoline first to boost the compressor speed. And then the raw materials. Just search on Baidu! There have been papers on this for a long time