Is it necessary to check the flange ring for clamping connections?
Thread Content
As the title suggests, how do you verify pipe flanges connected by clamps? Can SW6 be counted? How can you do it by hand if it’s not possible?
SW6---Component Design---Data Input---Clamp Structure/Toothed X-Type Clamp/Integral Clamp (there’s a character I can’t write)
On page 200 or so of GB150, the fluctuation up and down should not exceed 40 pages
It’s not integrated. A flange ring is welded onto the take over for clamping connection. How is this ring calculated?
Standard components can be simply selected; they are widely used in sanitary equipment.