Is there a parameter for corrosion amount that needs to be filled in in Caesar?
Thread Content
Is there a parameter for corrosion amount that needs to be filled in in Caesar? In the calculation of the pipe wall thickness, the amount of corrosion has been taken into account. Or is it not the same thing?
I’m writing this for others to read; it’s necessary for calculations.
As mentioned upstairs, it was said that something needs to be written, but the reason wasn’t explained clearly. Let me explain it. When calculating the wall thickness, a corrosion allowance was taken into account, which is intended to ensure a proper service life. In C2, the corrosion consideration takes into account the stress after wall thickness reduction. So the aspects considered are different.