I’m a newcomer to CAESAR, and I have a question – I hope the experts here can help me solve it
Thread Content
This post was last edited by Breathing is the sea on 2017-12-4 at 14:28. I have a question and would appreciate it if the experts here could help me solve it: While performing a stress analysis today, I accidentally entered the pressure value P2, and as a result, the situation shown in Figure 1 occurred during the analysis. This is different from what I got in previous analyses (Figure 2). I’m not sure what the difference between these two is! Is it possible for me to force a change from the analysis state table corresponding to Figure 1 to the state in Figure 2? Thank you
Check out my post: https://bbs.hcbbs.com/forum.php?mod=viewthread&tid=1870825&extra=page%3D1