[Process Engineering Division – Chemical Engineering Software Forum – Daily Question – Question 04-01]
Thread Content
【Process Engineering Section – Chemical Engineering Software Forum – Daily Question – Question 04-01】In AutoCAD, to move a circular object so that its center ends up at the midpoint of a line, which option should be used? ( ) A. Ortho mode B. Snap function C. Grid option D. Object snap function. Note: Questions are valid only for the day they are posted; 3 correct answers and 1 incorrect answer is required. Replies to previous posts in large quantities are considered spam and will not earn any points or may result in reduced points. =4
In AutoCAD, to move a circle so that its center ends up at the midpoint of a line, it is necessary to use: ( ) D. Object Snap