Aspen simulation of steam waste heat ORC power generation
Thread Content
For steam waste heat ORC power generation at 0.25 MPa, 120°C, and 18 t/h, Aspen simulation shows a low power output and reports a fault. Could an expert please help me figure out which settings are unreasonable?
The PIZZA equation of state has been removed, and the gas-liquid equilibrium modeling for the mass flow of water and steam has been changed to a gas-liquid approach
After making the changes, the heater gave an error message.
The steam volume is insufficient; increase the steam supply
The amount of steam in the device is fixed. Should we reduce the work quantity in ORC? How are the mass of the working fluid and the pressure determined in an ORC?
How to determine the most suitable working fluid volume and working fluid pressure?
Is your recirculating flow a heat pump cycle?
What’s your approach to the manufacturing process? Generate electricity using refrigerant expansion? !
The outlet pressure of your pump is incorrect, right?
This is the commonly used organic Rankine power generation!