Thread Content
When using CAD mechanical software for drawing, what should I do if the CAD menu bar doesn’t display in its entirety? Next, I will share with you solutions to the issue of an incomplete menu bar in the Haochen CAD tutorial. Solution for incomplete display of the CAD menu bar: Open the 2018 version of Haochen CAD Mechanical software, enter the ‘menuload’ command in the command line at the command area, select GCAD, EXPRESS, and GSTARCAD_MECHANICAL from the left side one by one, and then click the ‘Uninstall’ button. If it’s already not there, then there’s no need to perform this step. As shown in the figure below: After the uninstallation is complete, click the “Browse” button to locate the installation directory of the Haochen CAD Mechanical software. As shown in the figure below: If no changes were made to the directory during software installation, it will be C:\Gstarsoft\HaochengCAD Mechanical 2018\GstarCAD\UserDataCache\Support. Select the gcad.cuix file and then click the Open button. Click the load button again. As shown in the figure below: Repeat the above steps, select the express.cuix file (this is from the extension tools menu), and open it for loading. As shown in the figure below: 5. In C:\Gstarsoft\Haocheng CAD Mechanical 2018\Stardard\GRXx64, select the ji*e.cuix file, then click the “Open” button, and afterwards click the “Load” button. As shown in the figure below: 6. Finally, click the “Close” button, and the entire menu bar will be loaded. The above are the solutions to the issue of an incomplete menu bar in the HaoChen CAD tutorial; I hope they can help those who are learning to use the HaoChen CAD software~