Thread Content
When using the Haochen CAD drawing software to create drawings, some CAD shortcut commands are often employed to increase the drawing speed. Today, I’ll introduce the capture commands to you with examples! The steps for using the CAD capture command are as follows: 1. First, open the HaoChen CAD drawing software ； 2. In the diagram below, there are two rectangles; we will draw a circle at the midpoint between the two rectangles ； As shown in the figure below: 3. Click the “Circle” button on the toolbar on the left side of the CAD software interface, or directly enter the CIRCLE command ； 4. Do not perform any operations; simply enter the MTP command and press Enter to confirm ； As shown in the figure below: 5. Specify the first and second points according to the instructions on the command line. Here, we select the top-left corner point of the left rectangle and the bottom-right corner point of the right rectangle to determine the center of the circle ； As shown in the figure below: 6. In this way, a circle can be drawn at the center of the two rectangles. As shown in the figure below: There are actually many other ways to create drawings with the same result, but it can be seen that for those other methods, many more steps and auxiliary lines are required to draw them. However, by using CAD’s shortcut command mtp for drawing captures, the central object can be drawn directly, with relatively simple steps.