Which CAESAR axis limit bracket should be chosen?
Thread Content
Which CAESAR axis limit bracket should be chosen? Such as restricting node 610 in the x direction
X-direction limit, divided into + and -X directions. If limiting is done in only one of the + and -X directions, when entering data, simply select + or -X in TPYE ； If both + and -X directions are available, you can directly select X in TYPE.
Guid is the limit support
I entered it the same way, but I can’t see this bracket on the interface. What’s going on?
Change the display style. How to modify it? Could you explain in detail? Thank you
:Find a C2 operation manual; it has buttons for direct operation – just click on them. I don’t need C2 anymore; I haven’t installed it.
The axial direction of the pipeline is the X direction; therefore, for axial limitation, either X-direction constraints or LIM can be used. Both are fine
I believe the issue has been resolved now; the entity displayed by the model was blocking the limit clip, and it becomes visible when switching to a wireframe or similar mode.