“Help request: Could any expert help me figure out how to solve this problem?
Thread Content
There’s an active file uploaded here; could anyone please help resolve this? It’s urgent :(
Does the interlock record document need an explanation?
I just translated it – it says that your inlet concentration is below the minimum level required for separation, and you also lack hydrogen (? ) of the physical property parameters!
Yes, I don’t know how to solve this problem. Please give me some advice, experts
It can run without any loops, but once loops are included, it can no longer run
Actually, I’m not sure about how this simulation software works; I’ll just explain it based on the principles. Since it’s a loop, there must be certain conditions that determine when the loop ends – otherwise, after running for a while, the problem you mentioned will occur! For example, in the case of this simulated cyclone separator, it has a certain operating range; of course, it cannot continue to function if that range is exceeded. Personally, I think this reflects to some extent that the simulation software is quite realistic.