Guys, where in the Aspen EDR interface do you set the drain valve for shell-and-tube exchangers and the non-condensable gas vent valve?
Thread Content
Guys, where in the Aspen EDR interface do you set the drain valve for shell-and-tube exchangers and the non-condensable gas vent valve? There are also no settings options on the nozzle page.
In the Aspen EDR software, the specific steps for setting the drain valve and the non-condensable gas vent valve of a shell-and-tube heat exchanger are as follows: 1. Open the Aspen EDR software and select the shell-and-tube heat exchanger module that needs to be configured. 2. Select the heat exchanger you wish to configure in the module, and choose the “Shell and Tube” tab in the properties window on the right side. 3. On the “Shell and Tube” tab, scroll down to “Other Parameters” where you can find the two parameters: “Drain Valve” and “Vent Valve”. Make the settings separately. 4. If there are no corresponding setting options on the nozzle page, control over the entire shell can be achieved by making settings within the shell. I hope this can be helpful to you! .
There is no such option, and it’s not necessary either