The PSD distribution cannot be generated
Thread Content
Everyone, I would like to use a cyclone separator to simulate the dust removal process, but it’s not possible to generate a normal distribution during the PSD input process; the error message indicates that \"failed to create PSD Object from SPS engine\". 1. So is this an input error, or something else? Although the PSD calculation was not successful, my input information was displayed in the logistics information, but it did not appear during the subsequent separation simulation. So, is it necessary to complete the PSD calculation first in order to proceed with further calculations?
This error can be caused by various reasons, and further investigation is needed. It could be that the input parameters are incorrect, or there may be an issue with the software itself. It is recommended that you check whether the input parameters are correct, or try updating the software version, or contact the software support team for a solution. .
It seems that HYSYS doesn’t have a solid module; I’ll use Aspen instead, and just change the material properties from convention to solid