Could you help check? After the heat flow is cooled by the heat exchanger, why can’t I see the data on the gas-liquid phase?
Thread Content
I wonder why, after the heat flow is cooled by the heat exchanger, there is no data available on the gas-liquid phase Is there a problem with the simulation? As shown in the figure below, why is the heat flux always in the liquid phase, with no gas phase?
Post it to the Aspen section, in the software area; please provide more details in your reply
A methanol-water mixture becomes completely liquid at 40 degrees Celsius. I understand that this is an engineering concept, not a physical one, and the evaporation rate is low.
It has all turned into a liquid; this must be a physical property
Then it will all be condensed. If a gas phase ratio is required, it can be set directly