Regarding the grounding of DCS systems
Thread Content
Regarding the grounding of the DCS system, is the following schematic diagram correct? If it is incorrect, please advise.
It’s a very clear and straightforward grounding method, with accurate illustrations as well
This post was last edited by budaoweng123 on 2017-4-18 08:05. According to domestic standards, the two BUS lines are ultimately connected to the electrical grounding network. I recommend that you take a look at the HGT20513-2014 Standard for Grounding Design of Instrumentation Systems
The final workplace and the protected area are connected to the same main grounding grid
The final workplace and the protected area are connected to the same main grounding grid
The final workplace and the protected area are connected to the same main grounding grid
The final workplace and the protected area are connected to the same main grounding grid