I would like some advice on wiring electric valves
Thread Content
Some of the small-tank electric valves currently have a power rating of 200W; so, should the power cable be connected directly to the distribution cabinet, or how is it connected? Isn’t it a waste to connect directly to the distribution cabinet? The MNS distribution cabinet
Just look at the drawings to see how it should be connected; it’s best to go to the cabinet, as that serves a design purpose
:(I’m the designer~~~:$:$:$ Can a power cabinet that big be installed on-site?) I’ve never seen cabinets placed in the tank area
Is your solenoid valve controlled by a meter, or how does it work? If it’s just a button to start it, installing a simple wall-mounted distribution box will do. If there is an available lane, then allocate one. If a whole cabinet has to be built just for it, I guess one would be drowned in spit···
It’s an electric valve controlled by a gauge, but it needs to be powered. There are quite a few electric valves – 22 in total. I’m afraid even one cabinet won’t be enough
If so, otherwise it’s the wall distribution box; the main power supply comes from the MNS, with the circuit breakers of type DZ47 below it.