Differential pressure level gauge
Thread Content
What impact does gas accumulation in the liquid phase of a differential pressure level gauge have on the measurements? If it is a flow meter, what impact does gas accumulation in the pressure guide tube have on the measurement? Why?
I have a gentle question: what does it mean for gas to build up? Is it blocked?
Generally, gas present on the negative pressure side causes the measurement values to be lower; therefore, a gas collector needs to be installed on that side~
If there is air in the liquid phase of the level gauge, it depends on whether it is a single-flange or double-flange type, as well as on the pressure inside the container. In the case of a single-flange level gauge used in equipment at atmospheric pressure, there is generally no significant impact; only slight fluctuations may occur. However, with a double-flange gauge, this can result in an underreported level reading (when the liquid phase is under positive pressure) or an overreported level reading (when the liquid phase is under negative pressure). Bubbles in the pressure guiding tube have a significant impact on flow rate, as differential pressure flow meters generally have a limited measurement range. Especially these days, orifice type flow meters with low pressure loss are used, and the static pressure generated by a certain height of water column has a considerable effect on the differential pressure; moreover, a square root operation is required, which leads to large variations in flow rate. Therefore, differential pressure flow meters usually come equipped with two parallel condensation tubes, with an exhaust valve installed at the upper part.
If bubbles are always present in the pipeline, simply add a separation tank; this way, the diaphragm box will not come into direct contact with the medium, and as a result, it won’t affect the accuracy of the measurements, preventing them from being too high or too low
Why does an accumulation of gas affect the liquid level? What impact will it have on liquid level measurement if I deliberately adjust the pressure tapping point to be angled upward?
Why does an accumulation of gas affect the liquid level? What impact will it have on liquid level measurement if I deliberately adjust the pressure tapping point to be angled upward?
What is the reason why the mixture with gas shrinks? The damned word count is not enough
The presence of gas reduces the static pressure generated by the condensate or other substances in the pressure guide tube, resulting in a difference in static pressure between the two sides. This causes a positive or negative deviation from the initial differential pressure, and as a result, the liquid level becomes inaccurate.
The gas inside the pressure lead pipe causes fluctuations in the liquid level and flow rate, resulting in unstable readings.