Selection of copper nozzles
Thread Content
For power cables of 25~300, which type of copper terminal is suitable: DT? DTG? SC? JG? People might say that DT noses are good, but they’re expensive, and it’s not easy to connect them to the motor. I would like to use the SC type or JG type. Are there any regulations that prohibit their use? I work in construction; I try to save costs as long as it doesn’t violate the regulations……
It’s better not to think about him; just do one’s job honestly. It won’t cost much money to do this. If it’s done on a small scale, problems will arise over time. If you really need money, just get more cables – everything else will be available:@:@:@:@:@
Brother yes! When I purchase cables on my own, I definitely don’t want to run into someone as expert as you.
It mainly depends on the actual wiring location; generally, within high and low voltage cabinets, DT-type terminals should be used as much as possible for high voltage motor wiring. For low-voltage motors, low-voltage distribution boxes, and other devices where the wiring space is limited, other forms can be used.