Have you used Suntong before?
Thread Content
Has anyone used SITONG? Why does so few people use this thing? It seems quite convenient, but why is a tee used in all cases?
I have used it; it is used in places where a four-way connection is necessary. Who says four-way connectors are convenient? They’re generally not recommended; it’s hard to find them. If two three-way connectors can be used as a substitute, then use those instead.
Are there any other reasons besides the difficulty in purchasing it? Characters Numbers Numbers Numbers
It’s really hard to buy, not many are made! Every time our factory receives materials, the number of tees used is in the single digits, while there are countless elbows!
Last time I tried to use four connectors, I was criticized and had to switch to two three-connectors, unless it was absolutely necessary to use four connectors! As for the situations in which four-way connections are definitely necessary, I’m not sure either
What is the diameter? It seems that SiTong is used for small diameters. Are you still talking about the SiTong with dual LL configurations?
You’re just not familiar with the manufacturer – that’s all. What kinds of ball valves does SITONG produce?
Our previous propylene gas compressors were of the four-way type, belonging to the LL category with adjustable inlet and outlet directions; however, the inlet and outlet of the compressor remained unchanged.
Three-way valves are more commonly used; there are few manufacturers of four-way valves, and they are also more expensive. Ball valves and control valves for four-way systems are available from certain manufacturers.
The fluid properties of Sutong are difficult to control, it is used rarely, so there is also a limited supply in the market!