Can a container with an inner diameter of 1680 be supported by leg supports?
Thread Content
According to the JB/T4712 standard, the applicable range for leg-type supports is 400–1600. I am currently designing a container whose process requirements call for the use of leg-type supports, and its inner diameter is 1680, which exceeds the diameter range specified in this standard. Does that mean such supports cannot be used? If leg-type supports must be used, is it necessary to carry out some calculations? Experts from Haiyou, please offer some advice
According to the process conditions, leg-type supports can be designed with reference to standards, and calculations are required.
Leg-type supports can be designed, but the pressure and weight must be calculated carefully.
It’s fine to add a few more just to be cautious
Hehe, many times adding a bit more material helps to solve the problem of thickness, but what about cost-effectiveness?~
Reference the standard design for leg-type supports; calculation is required. We have done all those 3700 models
Just write “Refer to JB/T4712” in the standard number, and that’s it, right? If you’re unsure about the size, go for a slightly larger one; it’s best to do some calculations, as the specifications should be available.