Regarding pilot valves
Thread Content
I would like to ask everyone: What kind of valve is a bleed block valve, and in what situations is it used? In what scenarios are three-valve assemblies and five-valve assemblies employed? When installing transmitters, how do I decide whether to use a valve assembly, and whether to include vent and drain valves? Thank you all
The differential pressure of the pressure lead pipes (single or dual) must definitely be used; one of the five valve assemblies is used for draining liquid
The bleed block valve is a drain stop valve. When installing instruments such as pressure, flow, level, and analyzers, the process medium is led from the process line into the transmitter; a valve of this kind is required for ease of operation. The three-valve assembly is used in the installation of transmitters for differential pressure measurement. The three-valve assembly consists of three valves: one for the positive pressure chamber, one for the negative pressure chamber, and one for the balance valve ； Later, the drain valves for the positive and negative pressure chambers were also integrated together, resulting in the five-valve assembly. It’s up to you to decide whether to use a valve assembly or not. It can be used sometimes; other times, 5 separate valves are used, with the same result. Sometimes, a pressure gauge only requires a root valve for taking pressure readings. If drainage is needed, simply close the root valve first, then remove the transmitter, and slowly open the root valve to clear the pressure guide tube.
Oh, I see now. Could you explain it in more detail? Hehe
For instruments such as differential pressure transmitters and pressure transmitters used with media that are prone to condensation, crystallization, or deposition, drain valves should be installed to prevent dust, oil residues, tiny particles, and the like contained in the measured medium from accumulating within the pressure guiding tubes and sampling valves, thereby affecting the measurement results
Thank you; your explanation was very comprehensive. I’ll learn a lot from you*
The five-valve assembly is a bit more expensive than the three-valve assembly; if drainage is necessary, simply adding a vent will suffice! It’s economical and produces relatively clean emissions!
I am extremely grateful to everyone for their kind help in answering my questions; I hope to continue receiving your support in the future.