Seeking advice on the pressure of the cooling circulating water for electrolytic rectifiers! ! ! ! !
Thread Content
This post was last edited by sunjl1981 on 2013-1-6 at 23:57. What is the typical pressure of the cooling circulating water (factory tap water) for electrolytic rectifiers? What size pipe is needed? What is the wall thickness of the water pipe? # ， ， &
The pressure of the cooling circulating water for electrolytic rectifiers – namely the factory tap water – is determined based on each individual supply system; it is generally between 2 and 4 kilograms. The diameter of the pipes used must be determined according to the heat load, while the wall thickness of the pipes can be chosen using standard diameters; thick-walled pipes are usually not necessary.
General requirements: 1. The temperature of the feed water should be ≤30°C, and the pressure should be lower than that of pure water, in order to prevent the feed water from leaking into the pure water system through weak points in the gaskets. 2. The resistivity of pure water should be >120Ω, its temperature should be <35°C. The pressure of pure water in the rectification unit should be ≥0.1 Mpa; the maximum pressure should be set at 0.25 Mpa, while the minimum pressure should be set at 0.08 Mpa. 3. Read carefully the operating instructions for the pure water cooler equipment. This post was last edited by limingshuguang on 2007-12-12 08:57.]