water seal tank
Thread Content
Could you tell me the specific procedures for operating a water-sealed tank? It’s best to include a flowchart; the more detailed, the better
LZ should be more specific – where is the water seal tank used? What is the medium used for sealing, and so on. . . . As the name implies, a water seal tank uses water to seal off a certain gas, and the liquid level of the water seal needs to be calculated. The actual procedure should be quite simple – just maintain the proper level of the water seal to prevent it from being broken through. If you want to take it easy, let a small amount of water from the seal overflow: lol. I’m not sure if this is what you were looking for; P
After the water in the water-sealing tank is discharged directly from the inner tank to the outer tank, is it necessary to use a valve before the water in the outer tank is discharged into the sewage tank?
:o A diagram would help make it easier to understand. :Lol, if it’s an exhaust pipe, a valve should be installed; if it’s an overflow pipe, a valve isn’t necessary.
On one side, there is an overflow port that serves to allow excess water to flow out; the other side is used for draining water. When the water seal is broken and water flows into the outer tank, the water in that tank needs to be drained into the sewage tank. What I want to know is whether the valve used for draining water into the sewage tank is open or closed normally. Is it dangerous if it’s left open? If it’s closed, is it remote-controlled? Does it open automatically when the water seal is broken and then close again at some point?