Centrifugal pump operation problems
Thread Content
If the centrifugal pump is half empty, what may be the cause? /
Liquid parameters (Is it an easily vaporized liquid? ) However, most of the reasons are caused by poor suction end: handshake
Can LZ first explain what kind of situation is called half-time? I haven't heard of it yet! :lol
The inlet filter should be checked to see if it is blocked. This is usually caused by the media in the suction end pipe section being unsatisfied.
I don’t understand what you mean by half-empty. I wonder if the amount is not enough? If so, check out these! 1. Is there insufficient incoming material? 2. Cavitation. 3. The gas is not drained cleanly.
Insufficient intake volume； Inlet pressure is unstable ； The structural design is unreasonable (such as a regulating valve at the inlet, etc.).