Help in Yokogawa DSC3000
Thread Content
Why can’t the PID gauge switch to RCAS mode during simulation? How should the external circuit be connected? Which end to self-connect? But I’ve already connected the S10 terminal of SW-33 to the SET terminal of the PID module, haven’t I?
Same issue; 3 identical requests were posted: http://bbs.hcbbs.com/thread-124701-1-1.html http://bbs.hcbbs.com/thread-124277-1-1.html There is a suspicion of posting meaningless posts maliciously to make money； Subtract 10 wealth units ； Delete all other posts. Severe warning: if this happens again, the account will be banned
The rcas mode is representative of the ROMOTE CASCADE mode, right? We generally don’t use this pattern very often. . What are you going to use it for?
The PID module is very easy to use. Just connect the output directly to the output point. . . You can take a close look at the examples in the reference book. . .
Card version supported! DCS is always written as DSC. Should someone in the instrumentation field be more meticulous? If the system name for the Renheng River is written incorrectly every time, how can people believe that you truly possess knowledge of system configuration? It cannot help but raise suspicions of irrigation.
DCS, or Distributed Control System, is a commonly used control system in industry. DSC, or Differential Scanning Calorimetry, is one of the methods used in laboratories to determine parameters such as melting points
I’m sorry; it was my mistake in writing. Thank you for pointing it out!