On the selection of salt level gauges for salt dissolving tanks
Thread Content
I heard that in a salt dissolution tank used in saline solutions (where the salt inside is constantly dissolving and the solution remains at full level), it is possible to measure the salt level. I’m just not sure what kind of level gauge would be used for this purpose; please share some suggestions. This post was last edited by naska on 2008-5-27 09:58.]
It’s about measuring interfaces, specifically the interfaces of solids; I think a capacitive level gauge could be used for that
The radio frequency admittance level gauge is a good choice; we use this type of gauge to measure the interface between alkaline solutions and water as well, and it works well without sticking to the walls.
It’s about the interface – can a radio frequency admittance level gauge be used? Could you provide some relevant images or materials? Thank you everyone
We use float level gauges or baffle level gauges; they are both simple and effective. The original poster should give them a try.
It can’t be measured using radio frequency admittance; it’s a solid material, and calibration with a cursor is necessary, which is troublesome. An ultrasonic level gauge should work for this purpose.
Just stick a long stick in it and you’ll know; it saves so much money
The radio frequency admittance we use isn’t reliable; it needs frequent calibration；
Contactless level gauges should be considered.
Supports ultrasonic level gauges! It works well!