How to enter numbers with more than 3 digits after the decimal point in PRO/II?
Thread Content
This post was last edited by longkui1990 on 2012-3-29 08:50. How to enter numbers with more than 3 digits after the decimal point in PRO/II? I just worked through an example problem and noticed this issue. For example: I want to enter a pressure of 6.4563 kg/cm2, but the system defaults to 6.456, rounding it automatically. How can I change this setting? Thank you. This post was last edited by suiran983527 on 2009-2-11 15:43.]
Regarding the setting of significant figures for PRO, I carefully checked all the software menus but found no such function, and there is no information on this topic in the software manual either. I think the software might be showing rounded data; the actual calculation uses the data you enter
The answer is upstairs. But is there a place where multiple digits are displayed? For example, in the material properties table