Carbon ring gap
Thread Content
One of the turbines in our plant uses a \"four-carbon ring seal\" for its front and rear seals, resulting in severe steam leakage. What is the typical clearance between the carbon ring and the shaft? (If anyone from Yuntianhua is reading this, could you let me know if the steam leakage issues at the front and rear steam seals of the P-104 turbine there have been resolved?) How should it be handled? ) This post was last edited by lxzzl on 2008-7-23 12:29 ]
If you can control the gap in your carbon ring properly, you should be able to solve the problem