PROII – Material non-conservation
Thread Content
The twin-tower calculation process includes an inner loop; once the calculation converges, why does material conservation not hold? How can this be resolved? Please help solve this issue^_^ This post was last edited by suiran983527 on 2009-2-11 15:02.]
It is possible to set the allowable tolerance; the default value of 0.01 is a bit rough.
What was said on the 2nd floor is correct, but it needs to be recalculated. Sometimes such problems arise during calculations, but running it again will solve your issue in most cases!
Thank you both; the problem is solved^_^