How is this part processed?
Thread Content
There is a ring-shaped component made by bending steel pipes: the diameter of the steel pipe is φ630 mm; the wall thickness is 10 mm; the diameter of the ring is φ6000 mm. I would like to know: what processing method would be suitable for this component? What equipment can be used to ensure the quality of the component? Thank you in advance! This post was last edited by zzg5680 on 2008-12-13 at 16:35
For such large workpieces, it’s necessary to process them in segments; there’s no other good solution
How should it be processed in stages? Could you explain it in more detail?
Thank you for the active participation from the second floor! Could you go a bit deeper?
Personal opinion: It should be divided into at least 5-6 paragraphs. Special bending machinery should be used, and care must be taken to ensure that the pipe does not deform during bending; it is also advisable to carry out appropriate heat treatment. Welding is another very important step in this process
The difficulty of this problem lies in the bent pipes. I also have a headache about what kind of machinery to use for bending pipes. Additionally: if mechanical bending is used, it is not advisable to divide it into too many small sections. Thank you for your help1