How can PDMS modify the origin of a device? ? ?
Thread Content
For the combined device, its origin needs to be modified. How to do it?
We basically choose the \"building blocks\" approach here
Select the Equi that needs to be modified, use the Q ATT command in the command bar to view the device’s properties, and simply change the position in the position field – it’s very convenient^_^
There is a modification for equipment origin in modify! It can be set to a specific value, or using an explicit value – either way it can be modified!
Is this okay too? I haven’t tried it yet; modifying » equipment origin » allows for multiple ways to set points, such as capture points and definition points
For Q ATT query attributes, you can modify any parameter directly in the relevant location; as long as it is a visible attribute, it can be modified this way, while hidden attributes can only be modified by using the menu. This command is very convenient to use^_^
Hehe, it’s been mentioned quite a bit above; it seems there are quite a few experts in PDMS. As a supplementary note on the traditional method: 1. Go to the Equipment module (those who have used it know there are multiple modules, with Equipment and Pipes being the two most commonly used). 2. Select the layer where the equipment is located – it could be SITE or ZONE; pay close attention to this layer hierarchy. 3. Use the MODIFY menu and select EQUIPMENT ORIGINAL. 4. Then specify the origin point that needs to be set. An additional note: It is said that the origin point of the equipment is related to the pumping weight reports; I’m not sure what other reasons there might be for setting an origin point. Feel free to discuss this further: lol