What are the indicators for exiting the dust collection section and entering the purification section?
Thread Content
What are the indicators for exiting the dust collection section and entering the purification section? Especially the dust content
After the furnace gas from the waste heat boiler passes through the cyclone dust collector and electrostatic precipitator, the dust content
This depends on the specific purification process configuration. If it is a two-stage power wave configuration, the imported dust can be no more than 0.5g/Nm3.
The outlet of the electrostatic precipitator is 200mg/NM3, which seems to be* * Tentative standards. You can check and read them.
The dust removal indicator is that the dust content at the fan outlet is 0.05g/Nm3
Sorry, I didn’t see the topic clearly just now, it’s the dust indicator for purification! If it is restricted by the raw materials, if the dust content in the electrostatic dust is too high, even if the electrostatic dust removal efficiency reaches 99.5%, it will not meet the requirements. ； Therefore, some of the high dust content in purification is ≥0.5g/Nm3 ； Some are low
I remember: ： The dust content at the fan outlet is 0.005g/Nm3