Unable to paste
Thread Content
When pasting frame A in one file 1 to another file 2, after executing the paste command, the system prompts as follows, but it cannot be pasted after specifying the insertion point. Help! ! If there is no problem when pasting frame A into other files, there will be no problem when pasting other frame B into file 2. Order: _pasteclip ignores duplicate definitions of block zep. Ignore duplicate definitions of block 08 tags. Ignore the duplicate definition of block A1. Specify insertion point:
I haven't come across this before. Can you post the file and take a look?
It is recommended that the author copy and paste directly. It is the same as the operation in word. There is no need to use CAD language or directly Ctrl+C to copy and Ctrl+V to paste.
It is recommended to clean (PURGE) before pasting and try again.
Thank you! According to your suggestion, it can be pasted.
There may be blocks in the content pasted by the poster. You can break the blocks apart first.； Another reason may be that the ratio of the two files is too different. If it is too small or too large after pasting, the pasted content cannot be seen. It is recommended that the poster reset the ratio and try again.
It should be caused by a block with the same name pasted into the original picture.