Various specifications of tetrafluoro gaskets
Thread Content
Urgently need the specifications for various PTFE gaskets, such as those used for pressure gauges, transmitters, valves, etc. Thank you!
It seems like the on-site installation team handled this! :lol
Gaskets are determined based on the diameter and nominal pressure of the flange or fitting. What is the DN/PN of your flange? The gaskets are described in the same way.
Relevant information is also needed; looking forward to a good answer……
ANSI 1/2" 150LB RF T=2mm 2.0MPa 3" RF T=1.5 I’m not sure if this is the type of specification required
The connector of the pressure gauge is M20*1.5, the transmitter is from the EJA series, and the valve is PN64.DN10. I can’t tell the difference between them. Please advise!
For flange connections, it is sufficient to use the dimensions specified by the flange standards; the “T” value indicates the thickness. The same goes for threads. Just go with the standard configuration; our factory offers custom orders at low prices as well.