Problems encountered when using Aspen runtime
Thread Content
I’m using Aspen Plus 11.1 to simulate a program; I’ve entered all the required inputs, but whenever I run it, the following error message appears: ->Processing input specifications ... ****TERMINAL ERROR: AN ACCOUNT-INFO PARAGRAPH MUST BE PROVIDED ******************************************************************** * THE ERROR SEVERITY LEVEL IS 0
You haven’t entered a username. This is an issue with version D; you need to enter the username each time. Just type anything in the field labeled ‘Data/Setup/Accounting/Username’ – that’s the username. I hope this helps resolve your problem.:victory:
Thank you, zippowxy ~~~~~~~~ I finally see the result. . . . Thank you so much~~~
Hehe! You’re welcome; I’ve encountered the same problem as you before~ Keep it up! :lol
OP, I suggest you take a close look at the messages that appear after the software is run; there’s a lot of information in there that is worth studying carefully, as this will help you improve your skills. Unlike with the question mentioned above, the messages already tell you that you need to enter ACCOUNT-INFO PARAGRAPH