Loop selection in CAD
Thread Content
Cycle to select one of the two duplicated graphics: Select it with Ctrl+left mouse button, release Ctrl and the left mouse button, then use the right mouse button~~~
OP, could you explain in more detail? I’m not very good at using it. What does ‘cyclic selection’ mean?
Draw two identical circles, change one of them to red and the other to white (assume the one on top is red). Select one of the circles (by default, you can only select the red circle on top; the one below is hidden). Move the mouse over the circle and click the left button; the command line will display “Start cycle”. Keep clicking the left button, and you’ll see that the red and white circles alternate in being selected