How to improve the surface gloss of ASA
Thread Content
The current situation is as follows: 1. The customer is using co-extrusion of PMMA and PVC； 2. After conducting experiments with ASA, it was found that its gloss level is not as good as that of PMMA, and the extrusion melt pressure is lower than that of PMMA ； I hope to receive advice from experts regarding the materials (what additives can be used to increase the gloss of ASA while reducing precipitation on the surface), the design of the mold, the requirements for screws, and the processing temperature. . Thank you. This post was last edited by lclmary on 2008-4-11 17:10.]
Go and check the plastic additives manual; what you’re looking for is in there. There’s information on this topic in the forums, so learn how to search! :lol
I can provide some samples for testing, and technical support is also available to address any issues related to the use of raw materials