Welding process for 16Mn and stainless steel

2008-02-23View Original

Thread Content

For welding the tube sheet of a heat exchanger, where the sheet is made of 16MnR and the heat exchange tubes are made of stainless steel, what type of welding wire should be used if TIG welding is employed?

Reply #22008-02-25

II+VII first use H1Cr24Ni13

Reply #32008-05-14

This post was last edited by djkf123 on 2011-4-24 at 13:39. What is the grade of stainless steel? If it is 18-8, then refer to the welding procedures specified in JB4709; relevant information is also available there. If it is a foreign-grade steel, then ASME standards should be consulted. In any case, process evaluation must be successful before it can be used.

Reply #42008-05-14

H1Cr24Ni13 can also be used, but it seems to be a bit expensive!

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.

Welding process for 16Mn and stainless steel

Thread Content

Related Threads in This Forum

← Previous

Next →

Submit a Project

Disclaimer

Quick Links