Axial play of LMV-322
Thread Content
Regarding the shaft runout of the LMV-322, I would appreciate some guidance from those with experience – what is the typical value? The specification states 0.25 mm, while the regulations specify 0.33–0.43. What is a safe way to compare them? This post was last edited by zzg5680 on 2009-2-4 13:02.]
This is a high-speed pump from Nippon Kikai Seisakusho in Japan; please refer to the installation clearance table in the operation and maintenance manual. The specified range is 0.33–0.43, and there is likely an optimal clearance as well, around 0.35–0.40. A value of 0.25 is on the low side, but it should not cause any problems