Manufacturing of a soda separator
Thread Content
Our facility uses water-lubricated oxygen compressors with an ultimate pressure of 16.5 MPa. Currently, since there is a lot of water in the gas cylinders, we want to install a gas-water separator. The oxygen flow rate is 1,000 cubic meters per hour. How much investment is required? Could someone help calculate whether it’s feasible? What other parameters are needed? This post was last edited by fetn on 2008-2-26 17:41]
I’d appreciate it if the experienced folks could help out; even some suggestions would be great.:o This issue needs to be resolved urgently.
Are there any friends from design institutes in the forum who can take a look? :handshake
What we can do still requires many detailed parameters to be determined. I can’t say anything about the investment for now; it depends on how far you want to take things. How many PPM of water is currently present in oxygen? To what PPM level needs to be processed?
I’ve already contacted the person upstairs; I hope they can calculate the investment amount for us.
How is the steam separator built?